Q - Is installation difficult?
A - This is the easiest dumbwaiter on the market to install, this is key money saving factor over the competition.
[ Top ]
Q - What is the average install time?
A - A two stop unit with doors complete on average takes 6 hours one man.
[ Top ]
Q - Is there any electrical wiring required?
A - no, all connections are pre wired at the factory with quick connectors.
[ Top ]
Q - Where is the motor and drive system located?
A - The standard motor location is at the bottom of the shaft bolted to the load bearing wall support. Other locations available.
[ Top ]
Q - Does the dumbwaiter system meet my local codes?
A - Yes, all safety devises are included, slack cable sensor, upper final limit switch, door interlocks and emergency trolly brake are included.
[ Top ]
Q - Are permits required?
A - You must check with your local building department.
[ Top ]
Q - What are the maintenance requirements?
A - maintenance is minimal, annual inspection of drive system and cable assembly including the sheave assembly.
[ Top ]
Q - What is the speed of the dumbwaiter?
A - 30 feet per minute.
[ Top ]
Q - How many floors can be served?
A - 4 floors
[ Top ]
Q - What is the maximum travel?
A - 35 feet.
[ Top ]
Q - Can there be two doors open at the same floor?
A - yes, this is an up-charge.
[ Top ]
Q - Will the doors open if the car is not at that floor?
A - no, there are safety interlocks and the door will not open until the car is at that location.
[ Top ]
Q - Do the dumbwaiters come with hoist-way doors?
A - doors can be provided with pre-installed interlocks for an additional up-charge, or you can provide your own doors.
[ Top ]
Q - What is the shipping time after ordering?
A - Standard units ship in 1-2 weeks and custom orders can take 2-4 weeks to ship.
[ Top ]
Q - What is the warranty?
A - There is a two year limited warranty.
[ Top ]
|
